PRESSED STEEL SECTIONAL WATER TANK
GENERAL SPECIFICATIONS
Tank panels pressed with a combined double flange at an angle of 45 degree and 90 degree to the face of the plate on four sides.
The stays and cleats are made of steel angle bar and steel plate.
Hot Dipped Galvanised steel bolts, nuts and washers for internal and external.
Non toxic PVC foam to be used for all jointing between tank panel flange.
Standard :
PIPECO pressed steel sectional water tank constructed with hydraulically pressed flanged panels, conform to BS 1564 : 1975 and SS22 : 1979.
Materials :
The steel used in the manufacture of the tank plates, stays and cleats conform to the requirements of BS 4360 : 1972 grade 43A or ISO equivalent.
Panel type steel cover supported by trusses.
530mm x 530mm square manhole and PVC air-vent supplied as standard for each compartment.
Standard : Reverse Reading Pointer Mechanical Type (Cat & Mouse)
Optional : Direct Reading Clear Tube Type.
Short pipe with flange or socket for all pipe connections.
Aluminium or HDG Steel ladder for internal and external access, 300mm width.
None
Hot Dip Galvanised conform to ISO 1461.
| Type | 1.22m (H) | 2.44m (H) | 3.66m (H) | 4.88m (H) |
|---|---|---|---|---|
| 4th side panels | 5mm | |||
| 3rd side panels | 5mm | 5mm | ||
| 2nd side panels | 5mm | 5mm | 5mm | |
| 1st side panels | 5mm | 5mm | 5mm | 6mm |
| Bottom panels | 5mm | 5mm | 5mm | 6mm |
| Type | 1.0m (H) | 2.0m (H) | 3.0m (H) | 4.0m (H) | 5.0m |
|---|---|---|---|---|---|
| 5th side panels | 5mm | ||||
| 4th side panels | 5mm | 5mm | |||
| 3rd side panels | 5mm | 5mm | 5mm | ||
| 2nd side panels | 5mm | 5mm | 5mm | 5mm | |
| 1st side panels | 5mm | 5mm | 5mm | 5mm | 5mm |
| Bottom panels | 5mm | 5mm | 5mm | 5mm | 5mm |
*Note : Specification may vary according to customer requirements.